| Author | Vasconi, Thomas |
| Call Number | AIT Thesis no. WM-00-16 |
| Subject(s) | Sewage--Purification
|
| Note | A thesis submitted in partial fulfillment of the requirements
for the degree of Master of Engineering, School of Engineering and Technology |
| Publisher | Asian Institute of Technology |
| Abstract | This study investigates the performance of a high rate physicochemical process, called
Densadeg® used as a primary treatment. This research had been carried out on a pilot
plant located on an oceanic wastewater treatment plant in Sydney.
In order to evaluate the efficiency of this technology, it was decided to assess its
performance by running the pilot plant in dry weather and wet weather flow conditions.
The range of flow rate applied to the process was in the range of 40 m
3 /h to 65 m
3 /h (960
m3 /d to 1560 m3 /d). The chemical agents constituted of ferric chloride as coagulant and
anionic polymer whose dosage varied from 30 mg/l to 50 mg/I and 1.5 mg/I to 3 mg/l
respectively.
By increasing the flow rate, the TSS removal decreased from 80% to 26%, with an
average value of 65% for the study. The mean removal efficiency achieved for O&G,
TKN, TP and COD parameters were 57%, 49%, 12% and 47% respectively under these
operating conditions. |
| Year | 2001 |
| Type | Thesis |
| School | School of Engineering and Technology (SET) |
| Department | Department of Civil and Infrastucture Engineering (DCIE) |
| Academic Program/FoS | Water Engineering and Management (WM) |
| Chairperson(s) | Trankler, Ing. J. |
| Examination Committee(s) | Luketina, D. ;Visvanathan, C. |
| Scholarship Donor(s) | European Commission of the European Union
(PTS Program) |
| Degree | Thesis (M.Eng.) - Asian Institute of Technology, 2001 |